P1000 Won't start

[CumminsPusher]

Went through puddle it quit immediately. Won't turn over. Ideas that hopefully say locked Starter drains massive juice

 

[Admin]

 

[Hondasxs]

Ummm... Describe "puddle"?

Sent from my HTC6545LVW using Tapatalk

 

[Hondasxs]

Was the gas tank under? Have you ran the fuel breather line yet?

Sounds like water in fuel.

Sent from my HTC6545LVW using Tapatalk

 

[CumminsPusher]

Ummm... Describe "puddle"?

Sent from my HTC6545LVW using Tapatalk

Big

 

[Hondasxs]

Snorkeled fuel line yet?
No! Oh man - Fuel tank breather hose - IMPORTANT if you ride water!

Sent from my HTC6545LVW using Tapatalk

 

[CumminsPusher]

No. But found water in oil

 

[hondabob]

If it won't turn over you may have a broken piston jamming the engine up tight. If the hood went under water at high rpm I would remove the air filter and see if its wet. It may be ok to turn the engine back a bit. Is there water in the oil. The engine should turn over with the plugs out.

 

[Hondasxs]

Little water in oil will not stop from cranking. A lot will.

If the seat was under you have pumped lots of water into the tank.

Sent from my HTC6545LVW using Tapatalk

 

[Hondasxs]

If it won't turn over you may have a broken piston jamming the engine up tight. If the hood went under water at high rpm I would remove the air filter and see if its wet. It may be ok to turn the engine back a bit. Is there water in the oil. The engine should turn over with the plugs out.

Or that.. Let's hope not!

Sent from my HTC6545LVW using Tapatalk

 

[Hondasxs]

Lol... I totally missed the "want turn over part.. "
Haha.
Thanks Bob.

Sent from my HTC6545LVW using Tapatalk

 

[hondabob]

I would drain the oil and refill it up all the way. If it won't turn over either way you may need to pull the top end off. I have seen the flywheel key shear when an engine get water at a rpm of about 3,000 but the engine will usually turn over with the spark plugs out. You may have a broken balancer chain locking the engine but it should turn over the other way if its not jammed too much.

 

[CumminsPusher]

Little water in oil will not stop from cranking. A lot will.

If the seat was under you have pumped lots of water into the tank.

Sent from my HTC6545LVW using Tapatalk

I guess going to do an oil change.

 

[CumminsPusher]

I would drain the oil and refill it up all the way. If it won't turn over either way you may need to pull the top end off. I have seen the flywheel key shear when an engine get water at a rpm of about 3,000 but the engine will usually turn over with the spark plugs out. You may have a broken balancer chain locking the engine but it should turn over the other way if its not jammed too much.

That's my plan it needs new oil now anyway not going to lie I'm fairly nervous as a don't think warrentee will cover but one thing at a time. Thank you

 

[Bayouownbeer]

That's my plan it needs new oil now anyway not going to lie I'm fairly nervous as a don't think warrentee will cover but one thing at a time. Thank you

If you hear the starter engauging and it won't turn over with plugs out something is jammed in engine. If starter doesn't engage it's electrical

 

[CumminsPusher]

Ya that's where I am. There's nothing happening after starter. I was hoping someone else had same thing but a good ending

 

[joeymt33]

Oh crap! The OEM intake is very susceptible to water ingest due to being located up front. That's the main reason I snorkeled mine. I don't go that deep, I just don't want it to take a big gulp of splashing water.

Dang dude! Im sorry to hear that. I wish I could help but right now I'm clueless. I know you can figure pretty much anything out and if you're asking for our help, it must be bad.


Sent from my iPad 7G

 

[CumminsPusher]

It wasn't deep at all maybe 1 1/2 deep but hit it fairly hard. Trans was clean. Honestly I didn't see signs of water on the intake

 

[ghost]

Yeah - good luck man.
What Joe said x 2
I hope this takes a turn for the better.

 

[joeymt33]

Oh crap again, that oil doesn't look good.

What do you hear when you turn the key. Does it clunk like the starter engages but just can't turn the motor?

You could remove the cover plate and turn the motor by hand and get a definite answer if it's locked or not.

Man! I'm so sorry to hear that. I hope this ends better.


Sent from my iPad 7G

 

[CumminsPusher]

Won't turn over empty of fluid. It's off to the ""professionals" I guess. It'll be down awhile in there hands