P1000 New SATV Rear Bumper - Workmaster

[donia]

@donia
View attachment 318581

Was thinking about the bank scene, but we’re on the same movie wave length: Well, which is it, young feller? You want I should freeze or get on the ground ‘cause’ it if I freeze I can’t get on the ground….and if I get on the ground I’ll be in motion?

 

[Admin]

 

[P1K5Dave]

@donia

Aaaargh...I missed it. I bounced from OBWAT to Raising AZ and settled there. It was definitely Coen to me, an all-time Coen Bros fan.

all right then

 

[russknight]

Why is that?

Looks flimsy and I'm guessing tube wall isn't the thickest, but I could be wrong. I'm a fan of theirs, but not of this.

 

[bullyx]

Looks flimsy and I'm guessing tube wall isn't the thickest, but I could be wrong. I'm a fan of theirs, but not of this.

Ah, OK. Is see your points. Valid concerns

 

[SuperATV]

Looks flimsy and I'm guessing tube wall isn't the thickest, but I could be wrong. I'm a fan of theirs, but not of this.

I'll check it out for you and give you my honest opinion. This one slid by me.

 

[SuperATV]

Question….big NO Cutting or Drilling logo and “no drilling required” under the Features tab on the website, but the instructions tell you to mark and drill 2 holes for each side for the outer brace bolts? What gives…am I drilling or ain’t I, ‘cause if I’m drillin’ it ain’t rightly no drilling required…now is it??

🤣 🤣 🤣

Well....looks like my website guy didn't talk to my instructions guy. Lol! And this piece slid right by me.

It will require drilling some drilling.