P1000 Rear Bumper options

[priselay]

#101600 Honda Pioneer 1000-3 & 1000-6 Formed Bumper - KFI ATV Winch, Mounts and Accessories

#101600 Honda Pioneer 1000-3 & 1000-6 Formed Bumper KFI and other ATV Winches and KFI ATV winch mounts and Accessories

kfiproducts.com

Great Bumper!

 

[Admin]

 

[Moxdmguy]

Check out Texas Tough Customs. They have a rear bumper thats frame mount and you can put a winch on it if you want to. I have one of their front winch bumpers and it is super heavy duty. TTC Rear Winch Bumper (Bare Metal) | Texas Tough Customs

I’ve been very happy with this bumper. Was a bit of a challenge getting everything to line up for the install but is solid as a rock

 

[someguy1313]

Had the EMP. generally liked it for what it was. on post 5 and 6 here there are two SATV bumpers mentioned.

https://www.superatv.com/honda-pioneer-1000-5-workmaster-rear-bumper

and this

Honda Pioneer 1000-5 Rear Bumper

Get protection for your ride with SuperATV’s Honda Pioneer 1K Rear Bumper. Won’t interfere with dump bed/gate—Includes 2 tow-clevises—Made of 1.75” tubing.

www.superatv.com

any thoughts comparing between the two are appreciated.
want a reasonably durable bumper but if i'm pulling out of a hole, i'll be running off the receiver.

TIA

 

[ToddACimer]

I have the tuber bumper. It works well with my rear winch and HMF muffler. It does stick out to the full width of the roll cage and I have bent one side backing into stuff

I do like it as a strap storage spot. I only use the hitch for recovery

 

[someguy1313]

nice. thank you. looks like an easy install?

 

[ToddACimer]

nice. thank you. looks like an easy install?

Yes other than breaking the weld nut off the cage mount and having to weld a new nut into the back of the frame.

 

[someguy1313]

Yes other than breaking the weld nut off the cage mount and having to weld a new nut into the back of the frame.

View attachment 403857 View attachment 403858

good to know... can you advise the circumstance of the failure?

 

[ToddACimer]

good to know... can you advice the circumstance of the failure?

The nuts are welded into the end of the frame on 2 sides and likely are intended to be removed several times. The bolt was tight coming out likely from corrosion and the weld broke. I fished it out with a magnet and then drilled and oversized hole for a flange nut and welded the new nut in. Not perfect but not accessible another way

 

[someguy1313]

@ToddACimer
bumper failures suck.
thanks for the insight!