elkaholic
Illegitimi non carborundum
Vendor
Lifetime Member
I think you will have clearance issues at full lock in the front. The 28s on 5+2 are tight
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
I went back and forth with this very decision... I came to the conclusion it will work if you don't ride hard but that I would have issues if I didn't do aarms.. I bought 28's.Anyone know if 30x10x14 terrabites will fit on stock suspension? I've read a lot of people say they measure small and in some pics they looks small especially on the back. I have 4- 28x10s in my shopping cart I'm just hesitant to pull the trigger.
Well your clutches should hold up OK like that.
And the ride will be smoooooothWell your clutches should hold up OK like that.
Is it hard to keep it from sliding in the corners?
Harsh. Just harsh.Well your clutches should hold up OK like that.
Are you measuring with two straight edges from tire to tire at perfect opposites? I ask because that's how I measured my 27"s and they came out to an honest to goodness 27" on the dot. But I'm running 20 lbs so maybe that's why?Finally....
Pretty happy with the setup so far. Tires only measure 27 3/8" with 15psi, I wish they were an inch taller. Over all I gained 3/4" in the front but lost 3/4" in the rear? Not sure how that happened, I'll remeasure at a later time.
View attachment 52528 View attachment 52529 View attachment 52530 View attachment 52531 View attachment 52532
Are you measuring with two straight edges from tire to tire at perfect opposites? I ask because that's how I measured my 27"s and they came out to an honest to goodness 27" on the dot. But I'm running 20 lbs so maybe that's why?
I see. I assume this measurement was taken with the wheel/tire mounted on the machine. The weight of the machine will compress the tire a little so I'd bet if you measured the fronts and backs they would be 28". Good looking rig anyhow!I had a 36" straight ruler I stood up agaInst the tire and laid a small level on top the highest part of the tread ...
If they were an inch taller, you don't think you'd have clearance issues?Finally....
Pretty happy with the setup so far. Tires only measure 27 3/8" with 15psi, I wish they were an inch taller. Over all I gained 3/4" in the front but lost 3/4" in the rear? Not sure how that happened, I'll remeasure at a later time.
View attachment 52528 View attachment 52529 View attachment 52530 View attachment 52531 View attachment 52532
And remember...a 1" taller tire will only net you a 1/2" higher machine.Finally....
Pretty happy with the setup so far. Tires only measure 27 3/8" with 15psi, I wish they were an inch taller. Over all I gained 3/4" in the front but lost 3/4" in the rear? Not sure how that happened, I'll remeasure at a later time.
View attachment 52528 View attachment 52529 View attachment 52530 View attachment 52531 View attachment 52532
My biggest concern would be premature lower ball joint wear!