P1000 Accessory power from backup alarm..

[DPort]

Got ya..

That's the answer I was looking for..
so I'm surprised the 12volt accessory plug isn't heavier wire. Shame there isn't a subharness for the 1000...

I found connectors and seals for mine and ran the B/U signal and 12V signal wires together to the front in 18ga. wire
to run relays.

 

[Admin]

 

[JTW]

I found connectors and seals for mine and ran the B/U signal and 12V signal wires together to the front in 18ga. wire
to run relays.

Nice!

 

[ToddACimer]

The 700 accessory harness 08Z02-HL3-A00 plugs directly into the harness on the 1000 under the rear seat and behind the engine. This allows for plug-in power for a reverse light

 

[Jshell3]

Here's what @ToddACimer and I came up w/... (Mainly Todd - because I got confused)

I wound up clipping the "to lights" ends off and crimped on a universal quick connect. Taping up the rest, I made this funky looking harness.

Btw- harness is like $10.

 

[Jshell3]

Green end of harness plugs in here... in front of rear driver's tire just above the oil filters... Looks like this.

As it was discovered...

After I unwrapped it.

If I had it to do over again, I'd probably just posi-tap the wires, and turn it into a $1 quick connect harness... faster / cheaper.

 

[JTW]

Looks good!