P700 Switched power for relay

[jmanAZ]

Looking for a little help. I've read almost every post on switch panels, accessory wiring harness, and wiring in general. However, I still can't figure out what wire off the accessory harness goes to the relay. In the pic,I've attached, there are 2 open wires off my accessory harness that was installed by the dealer when they put the horn on (part of the street package when I bought the machine). My voltmeter shows 12v out of both wires in the pic. Can I use either of them to feed the relay for switch on power? I thought the white one would be ground.

Also, I need a switch panel and the founder is too swamped. I've reached out to Mystic, but nothing so far. Anyone know if he still builds panels?

thanks in advance and btw this is a p700-4 2020

 

[Admin]

 

[jmanAZ]

Hi everyone, any help here would help out alot. I can give more info if needed. Basically I'm asking if all the wires from the accessory switch are hot

 

[Hondasxs]

IDK... I don't recommend this unit because of how confusing it is and all the unused wires.
We have this item in the store that is a bit cleaner.

KEY ON POWER Harness for Honda Pioneer 1000, 700, 500, and Talon 1000.

Quick and easy KEY ON Accessory power source for your Honda Pioneer. PLUG-N-PLAY No Splicing of wires. No Tapping of wires. 3ft lead easily reaches anywhere under the hood. This kit plugs inline with OEM harness and provides a 12v positive lead. Use this Key-On Accessory wire to run the...

store.hondasxs.com

But I do know this...
Green is normally ground on Hondas.
The white with a black stripe should be hot.

 

[russknight]

I bought the above. It's a seamless, easy, plug and play way to do what you are wanting to do.

 

[jmanAZ]

Thanks Guys.

I bought the above. It's a seamless, easy, plug and play way to do what you are wanting to do.

thanks Guys. I'll just buy it and take off the harness from the dealer.

 

[Pedpole]

I used the harness from the store also. Less than a minute you have it hooked up and you have key on power..

 

[Reloder28]

I bought the harness from the store too. I used the 12v + to trigger a relay that connects a #12 awg to feed the switched side of my fuse panel. It gave me greater confidence In creating a bullet proof switched circuit feed.

 

[Hondasxs]

Appreciate all the feedback on this item, It's one of our top sellers.