Well had a box the size of a water heater outside the house, must have been my seats (as in TWO) uh nope a big arse box with one hmmmm.
Somebody had a bad Monday at the dock the other will be here tomorrow.
This will be a little more than I originally planned simply because I do not want to modify the OEM black plastic pieces that go under the drivers and passengers side, and at the same time going to address the heat that comes up from behind the various spots and big holes where the OEM seatbelts were. The OEM black plastic has some humps that keep the seat from being mounted "2 far enough back and there is nothing behind the humps, I was going to use a heat gun and push them back stretching the plastic then found out it laughed and snickered at my heat gun set on 500 degrees (that's dang tough plastic), the other option was to cut a few slits letting the seat push them back. So I removed all 3 pieces going across to verify frame cross-member placement wires etc. I will replace it with a piece of 14 gauge or 1/8" aluminum sheeting all the way across 22" wide X 42" long with a cutout in the center near the seat belt mount where the hump resides for Water cooling line etc. The small center piece of plastic may go back. The ECM under the passenger seat will be mount at the top of the vertical plastic immediately in front of where it snapped in the tray and the coil attached to the drivers side will be remounted off the plastic piece.
Anyway with the plastic out of the way plenty of room no clearance issues,, except the little hooped wings off to the sides where a proper door should be are juuuuust too narrow, I tweaked them out 1.5" on each side now it fits and dog gone nicely.
Oh you guys want pictures, figures LOL. Sneak peak below, I am 6'1" 295 pounds slightly larger than most KFC raised petites, I got about 2 " more leg room and I am happy as heck with the fit. I wish I had more metalworking tools I'd had all my brackets done.
Well when I Git-er-Done properly I will post detailed pics in my build thread showing the aluminum pan with heat shield material on engine side of it along with proper mounts and measurements. Once finished for a P500 it will be the pimp of the playground
![Smile :) :)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)