P1000 S&S Fabrication A arm guards

[Nightcrawler]

I took them off, and they definitely wont work if I swap them, they would be crushing the a arms. The side with the angled edge I think is the front side. Guess I am going to have to remove some material before they do too much damage. I have a hard time believing I am the only one with this problem though?

 

[Admin]

 

[Delton]

I fell asleep in the recliner so it may be in the morning before I can post pic of my setup. 40hrs in 3 days kicks my butt lol. Curious to see if you trimmed guards in same location I did.

 

[Delton]

Ok I forced myself outside lol. Pic of guards as viewed from rear

 

[Delton]

Pic of where I trimmed. I trimmed the vertical piece on left (facing front) right next to swaybar. It never rubbed but looked like it might.

 

[Nightcrawler]

Mine are on the other way. I just notched out some of the angled piece that you have facing the rear. You can see in this photo that I was making contact right on that angled piece that I would think was built in relief so this would not happen. If the flat side was in the front like on yours, I would have been having quite a bit of contact.

 

[Robobrainiac]

Does anyone have the contact information for s and s fabrication

 

[Delton]

Does anyone have the contact information for s and s fabrication

If you're looking to buy, gotta warn you he is going through some personal crap. Several ppl have ordered from him and can't get him to return calls or send out product.

 

[Robobrainiac]

If you're looking to buy, gotta warn you he is going through some personal crap. Several ppl have ordered from him and can't get him to return calls or send out product.

I tried to message him once but he never did respond.

 

[Delton]

I tried to message him once but he never did respond.

That's been happening quite a bit. I stopped recommending him because of this. Very good friend ordered a skid plate and it took forever to come in. Shame too cause Shaun makes some killer products.