P1000 Roll Bar Measurement

[tjoreo]

I was just curious if anyone new the hole spacing on the front lower roll bar. The location where you would install rear view mirrors by the cup holders. I know the bolt size is 12 mm but just looking for the spacing between the bolts. A friend of mine wants to put a front rack above the hood but they don't make the specific bracket for the 1000. I'm hoping I can copy the bracket for my 700 but his 1000 is not available for me to measure. Thank you in advance.

 

[Admin]

 

[Hondoman]

I was just curious if anyone new the hole spacing on the front lower roll bar. The location where you would install rear view mirrors by the cup holders. I know the bolt size is 12 mm but just looking for the spacing between the bolts. A friend of mine wants to put a front rack above the hood but they don't make the specific bracket for the 1000. I'm hoping I can copy the bracket for my 700 but his 1000 is not available for me to measure. Thank you in advance.

Assuming you are talking about here:

Im getting 1.1865" center to center as well as I can measure it.

 

[tjoreo]

Assuming you are talking about here:
View attachment 112125

Im getting 1.1865" center to center as well as I can measure it.

That's exactly what I was needing. Just the bolt center measurement. I'm hoping I can take a bracket and weld to the nuts on the inside of the roll bar, but I just needed the measurement so I can get them back in the correct place. Thank you very much.

 

[Hondoman]

That's exactly what I was needing. Just the bolt center measurement. I'm hoping I can take a bracket and weld to the nuts on the inside of the roll bar, but I just needed the measurement so I can get them back in the correct place. Thank you very much.

Anytime.