Repurposed Aluminum Bumper <>1st. made for Honda P700-4 <> ( Dealer said if it's Not Honda take it off ) when traded in.
Trimmed 5 inches Off each out side End.
Since the P700 & P500 series Honda "Have Simular Frame Width" adapting to the P520 frame didn't take much effort.
Since both have Dump box "Attachment is at the rear pivot point of the Box" using existing holes & "Tips With the Box"
Dropped the Bumper attachment 4 inches Below center of Box pivot BOLT.
Bumper is 8 inches toward the Rear from center of Box pivot Bolt.
Used flat steel plate with coupl 90° bends to stiffen.
Pictures show the rest.]
Pivots with Dump Bed & "No interference with Tailgate operation.
Trimmed 5 inches Off each out side End.
Since the P700 & P500 series Honda "Have Simular Frame Width" adapting to the P520 frame didn't take much effort.
Since both have Dump box "Attachment is at the rear pivot point of the Box" using existing holes & "Tips With the Box"
Dropped the Bumper attachment 4 inches Below center of Box pivot BOLT.
Bumper is 8 inches toward the Rear from center of Box pivot Bolt.
Used flat steel plate with coupl 90° bends to stiffen.
Pictures show the rest.]
Pivots with Dump Bed & "No interference with Tailgate operation.
