P 1000-5 width

[BHarris8753]

Odd question but does anyone have an exact width measurement of a 1000-5 stock deluxe with oem wheels? I have a 700-2 now and i have upgraded the wheels and they have a deep offset compared to the oem wheels so it has a much wider stance now than stock. The reason I'm am asking I am upgrading from the 700 to the 1000 and i don't want to upgrade trailers. My trailer now is 5.5x10 and the 700 fits very snug but does fit. Any thoughts?

 

[Admin]

 

[TxDoc]

Pretty sure 63.0 inches. If I'm off, someone will correct me. Length 117.6 in.(9.8 ft).

I had to upgrade from a 5x13 to a 7x14 with a dovetail. I needed some extra width to give me room to walk so I wouldn't fall post stroke.


Sent from my moto z4 using Tapatalk

 

[JenElio]

Odd question but does anyone have an exact width measurement of a 1000-5 stock deluxe with oem wheels? I have a 700-2 now and i have upgraded the wheels and they have a deep offset compared to the oem wheels so it has a much wider stance now than stock. The reason I'm am asking I am upgrading from the 700 to the 1000 and i don't want to upgrade trailers. My trailer now is 5.5x10 and the 700 fits very snug but does fit. Any thoughts?

It'll probably fit just about as snug as your current 700. Like @TxDoc said, I believe its right at/around 63" wide

 

[tdhanses]

Yup 63“ give or take a hair, it would be tight on a 5.5 wide but your length will be ok.

 

[BHarris8753]

Thank you for the reply. Online it says 62.9 but didn't know exactly where they were measuring. As long as thats edge of tire to edge of tire i can make it happen

 

[BHarris8753]

Im trying to not have to make 2 purchases at once lol, easier making one now and another after a few months of saving back up

 

[toddvdh]

From outside of tire to outside of tire is 63" wide with tires inflated so there is no bulge in the bottom.

The back tires are a fuzz narrower, but the cage is for sure 63" in the back.

 

[PJon]

Odd question but does anyone have an exact width measurement of a 1000-5 stock deluxe with oem wheels? I have a 700-2 now and i have upgraded the wheels and they have a deep offset compared to the oem wheels so it has a much wider stance now than stock. The reason I'm am asking I am upgrading from the 700 to the 1000 and i don't want to upgrade trailers. My trailer now is 5.5x10 and the 700 fits very snug but does fit. Any thoughts?

I updated my old heavy duty utility trailer early this year to accommodate my P1k5. Increased width to 65” and with stock 14” wheels and original tires, it fit fine. However the trailer is only 9’ long so I had to load with the P1k5 backed onto the trailer to get sufficient tongue weight. During the summer switched to System 3 (14x7 5-2) wheels and System 3 350 tires. When loading on trailer (still backing on) had to wiggle the steering to get the front tires to drop into side rails. A couple of weeks ago solved the loading problem completely by purchasing an Aluma 6812 trailer. Loaded P1k5 facing forward; found the point where tongue weight was correct; marked the location and installed the Erickson tie down system on all four wheels. Should cut down my loading and unloading by at least 10 minutes.

 

[sporttrac4x4]

It will fit if it is 5.5 wide