![SundayRdr](/data/avatars/m/4/4088.jpg?1493689421)
That is Wednesdays job, me and my 4 yr old will be home alone for a while and he likes helping me work on things when he can.Did you have a chance to install?
That is Wednesdays job, me and my 4 yr old will be home alone for a while and he likes helping me work on things when he can.Did you have a chance to install?
Black tape the latch and adjust the rubber bump stops out...should cure your rattlesI replaced the hinges on my 2016 P1k-5. Honestly I cannot tell a difference they still rattle ALOT. I recored videos before and after the hinges and you cannot tell a difference. I am not bashing the product it is very high quality but I just don't hear any difference between the new bushings and the factory bushings.
My driver door had around an inch of play (1/2" both ways) in the upper hinge. It rattled at idle. Going to have to order a set for the rears before the Take Over in april.I replaced the hinges on my 2016 P1k-5. Honestly I cannot tell a difference they still rattle ALOT. I recored videos before and after the hinges and you cannot tell a difference. I am not bashing the product it is very high quality but I just don't hear any difference between the new bushings and the factory bushings.
Did you adjust the hinges and latches?I replaced the hinges on my 2016 P1k-5. Honestly I cannot tell a difference they still rattle ALOT. I recored videos before and after the hinges and you cannot tell a difference. I am not bashing the product it is very high quality but I just don't hear any difference between the new bushings and the factory bushings.
You should adjust the latches on your pioneer. You can loosen the two bolts and move them up or down. And the rubber stops twist in and out. If you do this as well it should help. The bushing snug up the door so it doesn't rock freely up and down. But you should notice a difference after you fine tune it all.I replaced the hinges on my 2016 P1k-5. Honestly I cannot tell a difference they still rattle ALOT. I recored videos before and after the hinges and you cannot tell a difference. I am not bashing the product it is very high quality but I just don't hear any difference between the new bushings and the factory bushings.
Can you answer my question? I installed the 1" spacers you sell and the lugnuts stick out further than the spacer. My wheels are flat on the back and this won't work. Do you have shorter lugnuts that will work?Thank you very much! We put a lot of time and effort into making sure everyone is happy and nothing is left unanswered!
@RB3offroad I am in the same spot as well as I have new wheels on order in hopes of installing at end of week. I think about 1/8th is right but I am not in front of my rig nowGood morning @my99svt, I would be happy to try and help you! I am looking for a shorter lug length for you. The stock rims have a clearance spot behind the lugs so they don't interfere. How Close are your from being flat about 1/8"? If I cant find any I could always Turn them down for you.