Instrumentation Display failure

[ajoynt]

Just installed a power steering kit on my 2016 Pioneer 1000-3. When I performed a power up check and started the vehicle, the Instrument display was dead; no indications. I shut the vehicle off, disconnected the negative power to the battery and checked the fuses. No indication of blown fuse. Any suggestions on troubleshooting would be appreciated.

 

[Admin]

 

[Remington]

Welcome from the commie run state of Michigan.

how is your battery voltage?
if u disconnect the PS does it come back on?

Also need more info on your rig, miles hrs mods. Most important is pics of your rig. The issue at hand pics wouldnt hurt either! Also fix your location in your avitar from zip to state.
Pics Or It Didnt Happen!

 

[ajoynt]

I checked the battery, and the voltage was good. And yes, I disconnected the PS and the display still failed.

 

[Hondasxs]

Hi.
Where did you connect key-on power for the PS?

 

[ajoynt]

On the Red/White wire of the key harness, per the instructions.

 

[Remington]

On the Red/White wire of the key harness, per the instructions.

What brand PS kit did you buy?
Also, what type of connector did u use to tap into that wire?

 

[DRZRon1]

please post pics of your ride, first rule I learned was taught on here - Pics or It Didn't happen

did you check that you have +12V going to display? could be mis wired, bad connection, etc.

 

[ajoynt]

Thanks for all the inputs. Turned out to be a pulled pin in the display connector and I was able to repair it and it’s working perfectly.

 

[Remington]

Thanks for all the inputs. Turned out to be a pulled pin in the display connector and I was able to repair it and it’s working perfectly.

Thats cool it wasnt the PS or something you did and got it fixed.

Now, do us a solid and post some pics of that ride eh?

 

[DRZRon1]

thanks for rhe resolve,

needs pics and how you like the power steering