BWAF
I get paid to pass gas
Lifetime Member
Tigermark
Outside looking in.
Moderator
Lifetime Member
Supporting Member
Looks good brother! Nice job!
Eltobgi
Well-Known Member
Lifetime Member
Supporting Member
Club Contributor
Nice work Glock! 
The best thing about wiring are the final pics of a job well done Now go get that wiring dirty
The best thing about wiring are the final pics of a job well done Now go get that wiring dirty
E
elkguide
Well-Known Member
Lifetime Member
Supporting Member
Cuoutdoors
Executive Member
Lifetime Member
Looks great buddy. What did you do to your intake? I see the plate did you reroute it?
Sent from my SM-G960U using Tapatalk
GlockMeister
The Bearded Wonder
Lifetime Member
Supporting Member
Its snorkeled up behind the passenger seat.
mjn
Well-Known Member
Lifetime Member
Supporting Member
Very sanitary man! I dig it!
Can you show us more detail on the battery hold down???
Can you show us more detail on the battery hold down???
nbomar
Well-Known Member
Lifetime Member
Hahaha you should see mine @GlockMeister
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
GlockMeister
The Bearded Wonder
Lifetime Member
Supporting Member
Lol...i heard yours was the only one worse than mine
GlockMeister
The Bearded Wonder
Lifetime Member
Supporting Member
I didnt take any pictures other than that...but its just some 1/4" rod bent on the end 90° then drilled a hole on each side of the battery box. And a piece of flat strap on top. I also put some leftover foam around the battery for a little more snug fit
advertisement
Remington
Fife! POIDH Enforcement Officer
Lifetime Member
Supporting Member
Looks great man! Looks my my OCD wire job now. Lol
Tigermark
Outside looking in.
Moderator
Lifetime Member
Supporting Member
Don’t look at it Glock, you’ll get ptsd!
Ragnar406
The Great Bald One
Lifetime Member
Supporting Member
I got a pic of it somewhere... wire nuts and all
Smitty335
Well-Known Member
Lifetime Member
Supporting Member
Looks great! I'm so bad at wiring, I numbered both ends of every wire, so I wouldn't be more confused, HA!
GlockMeister
The Bearded Wonder
Lifetime Member
Supporting Member
Finally got my doors on @Delton and they are frickin sweet!! Shut solid as a Cadillac. Thanks again buddy !
Delton
Honda Fanboy
Vendor
Lifetime Member
Club Contributor
Looking at those never gets old lol. Now we need a badass cage and rear tube doors and you're set
GlockMeister
The Bearded Wonder
Lifetime Member
Supporting Member
Someday maybe..would like to take about 4 inches out of this cage.
BWAF
I get paid to pass gas
Lifetime Member
Those look really good
Sent from my SM-G930U using Tapatalk
Sent from my SM-G930U using Tapatalk
Delton
Honda Fanboy
Vendor
Lifetime Member
Club Contributor
I've never cut one down. Can't be that hard
GlockMeister
The Bearded Wonder
Lifetime Member
Supporting Member
So today when i pulled my rear floor board to put on my Joey designed heat shield i noticed a bubbled spot right where there have been a few holes melted through. Also my snorkel coupler had melted enough that when i got to moving around in there it fell out of the rubber connector.
So thanks @joeymt33 you heat shield should correct both of those issues.
So thanks @joeymt33 you heat shield should correct both of those issues.
advertisement
Similar threads
P1000
Chunk’s Bus Build
- MeigsP1000-6
- Pioneer 1000 Builds 2
