P1000 fuse block location

[Jankyeye]

X4 on the Velcro, the strap is just extra.

 

[Admin]

 

[russknight]

I made a couple of brackets out of some 3/16" aluminum. View attachment 349323

On a side note, the small terminal block behind the fuse block is key on power.

 

[kyrider1000]

I got rid of the stock breather and put in an oiled foam pre-filter. Freed up space and provides an easy way to prolong the life (and minimize service hassle) of the main filter:

View attachment 349447

Where did you get your foam breather at ?

Thanks Ride em safe

 

[bumperm]

I got it Here .

However, it shows out of stock, but at the link there are alternatives . . . just make sure the "pipe" size is correct. BTW, some earlier posts, by others, listed an aluminum coupling to use. I ordered that too, but had to cut one end off to use. Then I found that many common containers, such as WD-40 spray cans etc (maybe even a disposable propane bottle*) could be used for the coupling.

* if you use the propane bottle, assuming it's the correct size, be very careful cutting it open! I could see bad things happening if not done with care!

 

[snow5025]

I got rid of the stock breather and put in an oiled foam pre-filter. Freed up space and provides an easy way to prolong the life (and minimize service hassle) of the main filter:

View attachment 349447

Do you have part or part numbers for the pre filter in pic?

 

[bumperm]

Filter

This doesn't include the metal coupling needed. You can use an empty WD-40 or paint can - - if you have a way to cut it. Others have used this approach too (I'm not the original thinker on this one!). If you search I did a post with more info back around Sept. '21.