P700m4 Dash Plate Replacement Question

JaLerz

JaLerz

Member
Dec 1, 2018
40
31
18
NorCal
Ownership

  1. 700-4
The plate from pbr arrived super fast. Quality product. Metal with a nice paint job.

I drilled the rivets out with a 3/16 drill bit, the warning plate peeled off easily with help from a putty knife. I traced the slots for the switches with a sharpie and then cut out the plastic with a Dremel "plastic knife" torch. Worked perfectly.

All in all, it was a great fit and I am very happy with the PBR dash. Here is a picture of the rough draft.

If I remember, I will send the picture of my dash plate finished.

20181211 111851
 
  • Like
Reactions: GlockMeister
Neohio

Neohio

Beast of the East
Lifetime Member
Supporting Member
Club Contributor
Dec 22, 2016
14,496
72,631
113
Painesville Ohio
Ownership

  1. 1000-5
The plate from pbr arrived super fast. Quality product. Metal with a nice paint job.

I drilled the rivets out with a 3/16 drill bit, the warning plate peeled off easily with help from a putty knife. I traced the slots for the switches with a sharpie and then cut out the plastic with a Dremel "plastic knife" torch. Worked perfectly.

All in all, it was a great fit and I am very happy with the PBR dash. Here is a picture of the rough draft.

If I remember, I will send the picture of my dash plate finished.

View attachment 97442
Did you make individual holes for each switch?
Might be easier in the future if you make the hole this big.
Capture17