P1000 Camber question with SuperATV arms

Remington

Remington

POIDH Enforcement Officer
Lifetime Member
Supporting Member
Jul 24, 2016
20,335
116,357
113
Michigan
Ownership

  1. 1000-5

  2. Talon X
i believe question was camber setting yet instructions were for caster. not the same thing!
You know this thread hasnt had a post in over 2years?

At any rate, Welcome fellow Michigander!
start a new thread as an intro about yourself and your rig. Provide pics or Pics Or It Didnt Happen!
 
Plowboy1466

Plowboy1466

Well-Known Member
Lifetime Member
Feb 11, 2018
300
1,503
93
Ashland, Ohio
Ownership

  1. 1000-3
Hey Remi, some of us are slow and trying to catch up without starting a new thread asking the same questions that have already been answered. That's why l love this site. Soooo much info, but peeps just have to read.
 
P

PetePoling

Member
Jul 13, 2023
9
29
13
leo, indiana
Ownership

  1. 1000-5
i believe question was camber setting yet instructions were for caster. not the same thing!
It was my understanding that setting your arms with these measurements addresses both camber and caster...
camber is the main measurement out or the spacing and the reason for the different measurements from one side of the arm to the other addresses caster

clarification would be nice if anyone want to chime in because I'm getting ready to install front and rear arms and I'm using these measurements to set my machine up. Seem like everyone run superatv arms but no one talks about the alignment.
 
  • Like
Reactions: ODAMO
SuperATV

SuperATV

Well-Known Member
Vendor
Dec 5, 2013
1,650
11,998
113
Madison, IN
www.superatv.com
It was my understanding that setting your arms with these measurements addresses both camber and caster...
camber is the main measurement out or the spacing and the reason for the different measurements from one side of the arm to the other addresses caster

clarification would be nice if anyone want to chime in because I'm getting ready to install front and rear arms and I'm using these measurements to set my machine up. Seem like everyone run superatv arms but no one talks about the alignment.
Don't worry about caster. You'll be working with stock caster as long as you adjust your pivot blocks evenly for camber.