P1000 What am I doing wrong

[DSCKY]

Trying to install super atv flip out windshield with Honda roof already installed, but my top roll cage window mount hints exactly where roof mount is already located. What am I doing wrong .

 

[Admin]

 

[Dirtstiffs-1000]

Loosen both the roof clamps and windshield clamps.
Re align the windshield clamps loosely, then snap down the roof clamps, then tighten the windshield clamps.
I know, just loose fit everything first.
Its fits well.
I'll snack some pictures if you like.

 

[Dirtstiffs-1000]

Loosen both the roof clamps and windshield clamps.
Re align the windshield clamps loosely, then snap down the roof clamps, then tighten the windshield clamps.
I know, just loose fit everything first.
Its fits well.
I'll smack some pictures if you like.

 

[JTW]

Also... those little triangular pieces the shock mounts to are side specific.

 

[Plumber32]

X2

 

[DSCKY]

Thanks all. I have walked away for tonight, will try again tomorrow.

 

[Dirtstiffs-1000]

I also had to loosen the upper windshield so I could slide it from side to side.
Pretty much had all hardware loose to line everything up.
It was helpful to have a helper.
And, I almost took off the roof which would make easier.

Mirrors went on last.
PM me if I can help.

 

[DSCKY]

Got it!! Thanks all. Definitely had to loosen most everything. That was tough with one person.

 

[Bhinson]

just installed mine tonight. Had the same issues. I took the hardware off the upper windshield and installed the upper hardware loosely, then installed the windshield to the hardware. I tried to install per the instructions but with no help it was too awkward to maneuver under the roof to get upper clamps into place. Took about 90 minutes total but 30 were adjusting and tightening hardware. Good luck