P1000 Tail Light fasteners

[walexa07]

Damaged one of the rear body panels so bought a new one. Went to replace it and there are these plastic rivet nuts that the tail light screws go into that were not included. Has anyone else ran across this and if so what was your solution?

Thanks,

Waylan

 

[Admin]

 

[Remington]

Damaged one of the rear body panels so bought a new one. Went to replace it and there are these plastic rivet nuts that the tail light screws go into that were not included. Has anyone else ran across this and if so what was your solution?

Thanks,

Waylan

Ant say I have. But a pic of what u need would be very helpful.

 

[Neohio]

The tail lights use a rubber well nut. Shouldn't need to be replaced.

 

[HondaTech]

The tail lights use a rubber well nut. Shouldn't need to be replaced.

Half the time if you get them out they are impossible to reinsert in the new part due to being bulged out.

 

[walexa07]

The rubber well nuts did not come with the new body panel. Is a special tool required to install new well nuts into the new body panel?

Thanks,

Waylan