P500 start of full half doors

[jak9922]

oh baby can you picture this done

 

[Admin]

 

[jak9922]

just mock stage right now but getting closer

 

[trigger]

oh baby can you picture this doneView attachment 15768

Clip that front corner a bit and you could use factory latch. Covering with metal, fiberglass...?

 

[jak9922]

im going to use the factoy latch and either plastic or sheet metal not sure yet

 

[jak9922]

ur forgeting who can cut and weld

 

[trigger]

im going to use the factoy latch and either plastic or sheet metal not sure yet

I'm staring at that pic wondering how you'll make it work with the gas tank and fixed panels. Awesome concept, I'll be keeping my eye on this one.
Way to think outside the box Jak! Get it, outside the...forget it.

 

[jak9922]

lol ull just have to open the door to fill up and the door is going to cover the fixed panelim just going to remove the factory doors

 

[jak9922]

like this

 

[jak9922]

now u see what im working towards????

 

[trigger]

like thisView attachment 15781

That's what I was thinking, just leave those fixed panels alone. Might have to kick the hinge out a little to achieve the correct angle for door latch.
Very cool.

 

[Montecresto]

Nice jak, when are you going to get a shop, quit your day job and start fabricating??

 

[jak9922]

day job pays the bills so i can fab lol

 

[Montecresto]

day job pays the bills so i can fab lol

Roger that.

 

[jak9922]

2 matching door frames lol getting close

 

[ehart814]

2 matching door frames lol getting close View attachment 15853

Lookin good so far!!

 

[jak9922]

now just brace em up skin em weld hindges and latch mounts lol ugh

 

[trigger]

now just brace em up skin em weld hindges and latch mounts lol ugh

now just brace em up skin em weld hindges and latch mounts lol ugh

Take some good measurements jak. If they turn out like I expect they will, guys will be asking...like me!

 

[trigger]

now just brace em up skin em weld hindges and latch mounts lol ugh

now just brace em up skin em weld hindges and latch mounts lol ugh

Take some good measurements jak. If they turn out like I expect they will, guys will be asking...like me!

 

[jak9922]

no measurements so far by eye hand bending lol

 

[trigger]

no measurements so far by eye hand bending lol

Better only do the " by eye " on weekdays. Lol. We know what happens come Friday at quitting time.