P1000 Snorkel help

[Dave1967]

Ok people I'm snorkelling my mule . What is the best way to run the rear differential vent line? Seems like everywhere I go I'm getting pinched or it is on the heat shields.

 

[Admin]

 

[Eltobgi]

Ok people I'm snorkelling my mule . What is the best way to run the rear differential vent line? Seems like everywhere I go I'm getting pinched or it is on the heat shields.

I ran mine with the factory wiring on the drivers side of vehicle, to the center driver side ROPS and behind the seat! No issues! Just be sure not to over tighten tie straps when securing it.

To me that seemed to be the only safe route even for wiring.

 

[Dave1967]

I ran mine with the factory wiring on the drivers side of vehicle, to the center driver side ROPS and behind the seat! No issues! Just be sure not to over tighten tie straps when securing it.

To me that seemed to be the only safe route even for wiring.

Ok thanks. That was where I was looking last night. Wish they had made things a little tighter under there. Lol.

 

[ATM0816]

I also followed the factory wires but ran mine up the driver side mid roll bar. I drilled holes for all my vent lines and run them to the top and drill breather holes at the top.

Ok people I'm snorkelling my mule . What is the best way to run the rear differential vent line? Seems like everywhere I go I'm getting pinched or it is on the heat shields.

 

[Dave1967]

View attachment 77174 View attachment 77175
I also followed the factory wires but ran mine up the driver side mid roll bar. I drilled holes for all my vent lines and run them to the top and drill breather holes at the top.

That's where I ran mine .Buy I didn't want the holes drilled dobi just ran it up to the roof and ziptied it.