Roll Bar width front and rear on pioneer 700-2

[slowdryrider]

Haven't seen one yet even though I have ordered one.Can anyone measure the roll bar for me. The front width near the top and bottom as well as the rear top and bottom.Reason I'am asking is that I have a home made cab that I kept off the Ranger I sold in the spring.So why I'am asking for the widths is to see if my windshield and sliding back window will be useable on the Pioneer.If I can't make it fit then I'll have to possibly put my cab up for sale.Thanks.

 

[Admin]

 

[slowdryrider]

Anybody..Even measure the front width on there pioneer 700-4 I'am sure it'll be the same as what the 2 is thanks.

 

[chesterl35]

Do you need outside to outside or inside to inside on both?

 

[Hondasxs]

If no one responds. I will get this for you later tonight.

 

[BigRiver]

As close as I could measure by myself is as follows...

The front roll bar, upper position, below the bar (I have a roof that covers top of the bar).....49.5 "
The front roll bar, lower position, above the dash area.....49.5"

The roll bar above the seat, below the bar.....54"
The roll bar at seat height......57"

Again, these are approximate measurements, just to help if they can.

 

[slowdryrider]

Thanks for doing that.Big River. now I can figure out if my windshield and sliding back window will work. On the Pioneer.

 

[Hondasxs]

Thanks BigRiver.