P1000 Please someone help

[Heisenbeans]

I have a 2020 1000 5 and I'm replacing a front axle. I got the super atv model and I cannot find anywhere on the internet including the waste of 12 minute video i found to figure out where the o ring goes. It does not explain it anywhere and I cannot find one on the old axle.

 

[Admin]

 

[snuffnwhisky]

It goes on the outer end of the axle. Slide it past the threads and splines up against the cup. It seals between the outer cup and wheel bearing.

 

[snuffnwhisky]

#22

 

[TripleB]

#22

View attachment 242012

I was looking the other day and the 2018 diagram didn't have the o-ring.

 

[tdhanses]

I was looking the other day and the 2018 diagram didn't have the o-ring.

View attachment 242026

Isn’t it still #22 in this just at a diff spot on the diagram?

 

[TripleB]

Isn’t it still #22 in this just at a diff spot on the diagram?

Yes but its omitted from the parts list below.

Maybe it only comes with the boot kit. Idk

 

[snuffnwhisky]

Some models did omit it. Not sure why. I would still put it on.

 

[HondaTech]

Isn’t it still #22 in this just at a diff spot on the diagram?

I believe #22 in the 2nd diagram is the circlip for LE inner joint. They dont use a snap ring to hold the cage on. They use a circlip similar to a Talon.

I dont know why they got rid of the O-ring on the LE and Talon. Its probably the sealant they tell you use on the splines instead.

 

[Heisenbeans]

Thanks for the help. I figured it out