P1000 Motoroof Wind Jammer Rear Panel

[MountainMan]

Has anyone purchased the Motoroof Wind Jammer Rear Panel?

Pioneer 1000 Wind Jammer Rear Panel - Side By Side Stuff

If so, how do you like it? It looks like it could be used for both the rear and mid panel. It attaches with bungee cords so it looks reasonably flexible. These are the published features::

• Installs in minutes with zero modifications to your vehicle
• No flap design that stays attached smoothly at any speed
• Greatly reduces dust rollback while driving
• See through transparency
• Rugged UV resistant Razortex mesh
• 100% made in the USA!

 

[Admin]

 

[Glover88]

I couldn't see spending $140 on it. Picked up a mesh tarp and grommet kit from Harbour Freight. Cut it out sewed some nylon on the edges and installed the grommets. Had under $50 in the whole thing. I plan on making the next one a little taller. This one was a little short but still fuctions good.

 

[mx1alex]

I couldn't see spending $140 on it. Picked up a mesh tarp and grommet kit from Harbour Freight. Cut it out sewed some nylon on the edges and installed the grommets. Had under $50 in the whole thing. I plan on making the next one a little taller. This one was a little short but still fuctions good.

View attachment 99241

So do you like it or would you rather have a solid material to block more air/dust?

 

[haf]

I couldn't see spending $140 on it. Picked up a mesh tarp and grommet kit from Harbour Freight. Cut it out sewed some nylon on the edges and installed the grommets. Had under $50 in the whole thing. I plan on making the next one a little taller. This one was a little short but still fuctions good.

View attachment 99241

Im looking into making one like yours. Can you share the dimensions you used?