P1000 Lightbar Wiring Harness

[Mvalerio89]

I purchased a lightbar and wiring harness. The harness connects directly to the battery and has power all the time. Is there a way to wire the harness to where it only gets power when I turn the key on?

 

[Admin]

 

[rickoshea]

P1000 - Key On Power, Illumination, and backup source! - Honda Pioneer 1000 | The Honda Side by Side Club!

 

[Hondasxs]

What does the pre-wired switch look like?

Sometimes.
You can snip the trigger wire and hook it to a key-on source.

 

[Mvalerio89]

What does the pre-wired switch look like?

Sometimes.
You can snip the trigger wire and hook it to a key-on source.

 

[Hondasxs]

Ya.. idk.

But concept is still the same though.
1 hot wire.
1 trigger wire out.
1 ground wire.

 

[IvanGirderboot]

Is that a Rough Country/Cree light bar switch? As others have said, you just need to grab ACCY (Key-On) power and then run the light bar through a relay that's controlled by the Key-On power. You'll want to use a relay because the ACCY circuit is shared with other items and is limited current. For a standard automotive relay, the wiring would be as follows:

• remove the light bar positive connection and connect it to 87
• connect the battery to 30
• connect ground and key-on accy power to 86 and 87 (either way)
• (If the relay has am 87a terminal , it will not be used)

A detailed write up about relays with lots of pictures can be found at this page, if you're looking for more info.

 

[Hillbillytnt]

Does this plug into another harness running to your relay. If they are black blue and white like most eBay harness then you need a five pin switch.