P500 Just Venting

[trigger]

Can anyone tell me what all needs to be vented after a snorkel install? And where the original vent hoses might be located? Where you went with them for extension? I've seen the one coming off the front differential, comes up and hooks to a nipple on upper square frame. Also, that hose looks small, is it 1/4" or 1/8"? Any help is appreciated.

 

[Admin]

 

[Jshell3]

I know there are some kits out there. Peeps that have it down to a science. But I don't know, myself.

@Bayouownbeer makes kits for the P1k. Maybe he can guide you.

Any maybe ask @William he's posted a vent thread about fuel lines.

 

[Talen]

I don't know size. I cut little piece and took to advanced auto. Gave me some thing very close. Ran that one up to top of hood on top of dash. And ran rear and had tank breather up rear of cage to about top of seat. High enough for me

 

[500oneer]

Can anyone tell me what all needs to be vented after a snorkel install? And where the original vent hoses might be located? Where you went with them for extension? I've seen the one coming off the front differential, comes up and hooks to a nipple on upper square frame. Also, that hose looks small, is it 1/4" or 1/8"? Any help is appreciated.

Mud puppy on YouTube just posted a video about it yesterday.

 

[William]

Front and rear end, fuel pump, cooling fan, and water pump. I ran one hose from the front diff and fan motor to behind seat. Just put a tee in under hood. The water pump is not that important to vent, so I just put a filter on it and didn't run it up. It all comes up behind passenger headrest. Just take the hose to parts store and match it up.

 

[William]

I say take the hose to the parts store because for some odd reason vacuum hose from different stores are sized differently. Different brand I guess...?

 

[Shadesmn]

Water pump?

 

[Hondasxs]

Water pump?

No. The WP needs to drain. Just insure the small pipe is still on it.

Sent from my HTC6545LVW using Tapatalk

 

[trigger]

Front and rear end, fuel pump, cooling fan, and water pump. I ran one hose from the front diff and fan motor to behind seat. Just put a tee in under hood. The water pump is not that important to vent, so I just put a filter on it and didn't run it up. It all comes up behind passenger headrest. Just take the hose to parts store and match it up.

So front and rear diff's, fuel pump and cooling fan? Four things and that's it? Is there any advantage to increasing the size of the hose?
I checked in with @Bayouownbeer before this thread, vent and heat mat kits, but only for the P1. I did watch mud puppy's video, that helps. Don't plan on drilling those holes in the ROPS though. Thanks again guys!