P1000 Jump Wire for Rockerswitch

[Hachez]

I am getting ready to install my rockerswitch panel and wire some accessories. This might sound like a rookie question but if I want to put two 14 AWG wire in a push on female terminal, therefore creating a jumper, what size should the female push on terminal be?

 

[Admin]

 

[Jdiehl7]

I am getting ready to install my rockerswitch panel and wire some accessories. This might sound like a rookie question but if I want to put two 14 AWG wire in a push on female terminal, therefore creating a jumper, what size should the female push on terminal be?

.


Sent from my iPhone using Tapatalk

 

[Hachez]

I use a 14-16 gauge connector and have no issues. The blue one.


Sent from my iPhone using Tapatalk

yes but I am sure you are not putting two 14 awg wire in the 14-16 gauge connector?

 

[Neohio]

Best way would be use piggy back spade connectors.

 

[Jdiehl7]

yes but I am sure you are not putting two 14 awg wire in the 14-16 gauge connector?

Do it with the blue butt connectors all the time, gotta get your wires tight though.


Sent from my iPhone using Tapatalk

 

[Jdiehl7]

yes but I am sure you are not putting two 14 awg wire in the 14-16 gauge connector?

If you use a yellow connector you have to double the 14 Awg wire over to get a good crimp. I made my piggyback last night with a yellow connector because I had to do two 14 awg in and 2 out for the grounds for switch and lightbar.


Sent from my iPhone using Tapatalk

 

[Hachez]

If you use a yellow connector you have to double the 14 Awg wire over to get a good crimp. I made my piggyback last night with a yellow connector because I had to do two 14 awg in and 2 out for the grounds for switch and lightbar.


Sent from my iPhone using Tapatalk

Thanks