P1000 Fancy connecting rods

[ku4ns]

I need a little help with which rod bearing to order. I can see a small Roman numeral 2 but I can't see a color on the rod beating itself. I followed the other thread with a similar problem but still need some assistance.

 

[Admin]

 

[CumminsPusher]

Not sure on bearings I was pretty sure on only one set available, but I'd replace the studs and nuts. They didn't hold to factory torque settings for me so had to replace them. They use the same part number as an older Honda Civic so easy to get ahold of.
Was this a water ingesting issue?

 

[ku4ns]

Not sure on bearings I was pretty sure on only one set available, but I'd replace the studs and nuts. They didn't hold to factory torque settings for me so had to replace them. They use the same part number as an older Honda Civic so easy to get ahold of.
Was this a water ingesting issue?

Yes, it did go for a swim. They're three different sets of bearings available for these.

 

[CumminsPusher]

Yes, it did go for a swim. They're three different sets of bearings available for these.

Documentation doesn't really exist on these and is a pita.
@GPR1500SC can you shine anything on this?

 

[GPR1500SC]

Documentation doesn't really exist on these and is a pita.
@GPR1500SC can you shine anything on this?

My rods where fine I am still run my original bearings no help here.

 

[DG Rider]

Yikes!

Looks like a Salvador Dali painting,

 

[pct]

They had to order mine from the color code on the crank. Hope this helps

 

[ku4ns]

They had to order mine from the color code on the crank. Hope this helps

It looks like white on the counter weight of the crankshaft. I have that in the photo, is that the correct location or is it in a different area? Thanks for the post, I don't want to order all of them to make sure I have the right one.

 

[pct]

I would check with a tech,I will check with the service dept tech that rebuilt mine and find out for you