P1000 Fabricated A-Arm guards??

[Jimmyscoin]

I have access to a sheet metal shop here at work and wanted to know if anyone has made their own A-Arm guards or skid plates. I searched our forums but could not find anything. The skid plate seems kind of easy, just measure, mark holes and cut. The A-Arms seem a little more difficult with the bends and all. I am looking for a set of blueprints basically. Can anybody help? Thanks

 

[Admin]

 

[popeye]

I cant help you with any blue prints. But think its a good idea. After getting mine i wasnt impressed to see that you just use over sized fender washers and a hex head bolt to hold the skids on. It would take only a tiny bit more work but using xounter sunk allen head screws would leave the bottom side smooth and flawless

Sent from my LGMS631 using Tapatalk

 

[popeye]

You could use your factory skid as a template for the center section

Sent from my LGMS631 using Tapatalk

 

[GlockMeister]

I built my own center skids...I used the stock skid for measurements

 

[Jimmyscoin]

I built my own center skids...I used the stock skid for measurements

I am going to fab everything. I will post dimensions for everyone else

 

[Kilo427]

I am going to fab everything. I will post dimensions for everyone else

Good idea!