Thanks! I wouldn’t mind a small lift but not at the sacrifice of geometry or travel. Thanks for all the fast replies! First SXS ever and trying to know the do’s and fonts.Yes it does. The front are close to parallel but the tire rod is not quite inline so when you lift itll pull the toe out on the front.
The rear arms are not parallel at all 5 inches of lift and your negative camber a good bit. But manageable with lower adjustable arms. But i would recommend taking camber to 0 with out having top and bottom control arms adjustable that way when it compresses it doesnt push on the rear end or if top adjustable over extend the axle
Sent from my moto z4 using Tapatalk
I ran 2.5 lift for yrs now im at 5 inches and because im on portals the rears are very noticeable but bearing for portal output are fairly cheap. And im about to build rear arms. You could go 5 inches up front and just adjust the tire rods no prob. Alot are doing 5 up front 2.5 in rear.Thanks! I wouldn’t mind a small lift but not at the sacrifice of geometry or travel. Thanks for all the fast replies! First SXS ever and trying to know the do’s and fonts.