P700 buckle housing

[jmanAZ]

Hi guys,

My 2020 700-4 has these net buckle clamps on each side of the front roll bar. Since I dont use the nets is ok to remove them permanently, so I can fit my led bracket on better? they're just held on with 2 torx srews. I would assume so as they dont appear to be there other than to serve as a buckle for the net.

 

[Admin]

 

[Mudwing]

Hi guys,

My 2020 700-4 has these net buckle clamps on each side of the front roll bar. Since I dont use the nets is ok to remove them permanently, so I can fit my led bracket on better? they're just held on with 2 torx srews. I would assume so as they dont appear to be there other than to serve as a buckle for the net.
View attachment 211993

If you want, take them off. Shouldn’t mess anything up. 😉

 

[jmanAZ]

roger that. I noticed the older models of the 700 didn't have that brace, so prob ok. I'll just try not to roll it so I don't have to find out if those braces do anything.

 

[FlipKing]

I took mine off day 1. No problems.

 

[NewHere2]

The holes where the brackets mount are also used for the door latches if you install a Honda full cab. Shouldn't be a problem.

 

[jmanAZ]

The holes where the brackets mount are also used for the door latches if you install a Honda full cab. Shouldn't be a problem.

sounds good. thx for help