Brake light wires

[iowaguy]

Haven’t been on here for a while,how you all doing?I got into wiring side by sides for turn signals, I make up my own harnesses using 4 wire trailer harness and don’t use any of the factory wiring harness.I have done about 15 so far all different makes and models.I wired up 4 pioneer 1000’s.One of them called back and wanted to know if I could wire the rear signals into his brake lights with the lights I installed in the rear.Before I tell him to bring it to me I was wondering if each brake light is on its own wire or if they are both on same line?
Thanks

 

[Admin]

 

[Hondasxs]

Under the bed of the p1k 16-2021.
There is a 6 pin connector.
There each light has it's own wire.
Ground. Tail. And brake.
But I'm sure they are sourced from the same spot.

Sent from my SM-G996U using Tapatalk

 

[HondaTech]

Under the bed of the p1k 16-2021.
There is a 6 pin connector.
There each light has it's own wire.
Ground. Tail. And brake.
But I'm sure they are sourced from the same spot.

Sent from my SM-G996U using Tapatalk

They are fed by a single wire up to that connector.

Isnt there a company making a turn signal kit for Talons that uses the oem rear lights for signals? Im sure the Talon is set up the same way, fed by 1 set of wires and splits to each side somewhere.

 

[Smitty335]

They are fed by a single wire up to that connector.

Isnt there a company making a turn signal kit for Talons that uses the oem rear lights for signals? Im sure the Talon is set up the same way, fed by 1 set of wires and splits to each side somewhere.

Ha! Now the Wizard is thinking!