P1000 2017 Clutch dragging problems

[Lisa86]

My 2017 3 seat 1000 is pulling when in gear with no throttle. I attempted the clutch relearn but couldn’t get it to do it. I think the seat belt bypass is keeping me from the relearn. My question is what could be the cause. What can I expect to destroy by just riding as is.

 

[Admin]

 

[Plowboy1466]

My 17 does it to. I didn't seem to notice it before the clutch housing upgrade. It's definitely worse when it's cold. I did the the clutch relearn a couple times and it didn't make a difference. I hope someone has a good answer!!!

 

[TripleB]

My 2017 3 seat 1000 is pulling when in gear with no throttle. I attempted the clutch relearn but couldn’t get it to do it. I think the seat belt bypass is keeping me from the relearn. My question is what could be the cause. What can I expect to destroy by just riding as is.

I have a new clutch pack in case it s***s the bed. I have the seat belt bypass and have done the relearn numerous times.

 

[Plowboy1466]

I have a new clutch pack in case it s***s the bed. I have the seat belt bypass and have done the relearn numerous times.

So it still drags???

 

[TripleB]

So it still drags???

I dont have any problems. I was just letting Lisa know that if their clutch pack is toast, I have a new one that they can install to make it through this weekends ride.

 

[Lisa86]

I have a new clutch pack in case it s***s the bed. I have the seat belt bypass and have done the relearn numerous times.

f***in A your my hero big guy. I can’t let the Kawasaki finish a ride while the Honda sits. Thanks. Ohio4x4 out

 

[0860silverado]

I've noticed that when my engine oil gets toward the end of it's service life, my clutches start dragging too. As soon as I do an oil change, the drag goes away. Is your oil past due for a change?

 

[HBarlow]

My 2017 3 seat 1000 is pulling when in gear with no throttle. I attempted the clutch relearn but couldn’t get it to do it. I think the seat belt bypass is keeping me from the relearn. My question is what could be the cause. What can I expect to destroy by just riding as is.

Is your engine idling faster than it should? Compare your idle rpm with someone else whose clutch is not engaging at idle.

If the clutch is dragging (partially engaging) it is accelerating wear on the clutch pack. If it continues I think you'll see early clutch failure.

 

[HondaTech]

What does it do when attempting the relearn? Seat belt bypass wont affect anything.

 

[TripleB]

What does it do when attempting the relearn? Seat belt bypass wont affect anything.

It just wasn't getting warm enough idling. It wouldn't even start the relearn even though it had been running for 15 minutes or more. I just give it some throttle for a couple of minutes and the relearn worked then.

 

[HondaTech]

It just wasn't getting warm enough idling. It wouldn't even start the relearn even though it had been running for 15 minutes or more. I just give it some throttle for a couple of minutes and the relearn worked then.

Even when the 2 bars on the coolant gauge first pop up the unit isnt warm enough.

The oil has to be a certain temperature before the relearn will process.