P1000 1000-3 maintenance question

[Kelldog]

I installed a full skid plate so obviously i cannot determine what drain plug is what based on a close up pic of the drain plug with no skid plate around it. If that makes sense. So looking for a single picture of all the drain plug locations with the description. With the idea i can go by physical location of the overall machine to locate which one it is rather than the hardware around the drainplug for identification . Hope this makes sense

 

[Admin]

 

[CID]

I installed a full skid plate so obviously i cannot determine what drain plug is what based on a close up pic of the drain plug with no skid plate around it. If that makes sense. So looking for a single picture of all the drain plug locations with the description. With the idea i can go by physical location of the overall machine to locate which one it is rather than the hardware around the drainplug for identification . Hope this makes sense

I had the same problem with my Talon, replaced the skid, had no idear where the drain plugs were. Although this is a stock Talon skid, the drain plugs are in the same place as your P1K3 -

 

[Kelldog]

Oh ya! Awesome!

 

[toddvdh]

I believe both the engine oil are 12mm. And the subtrans is 17mm.

So don’t switch sizes could be a rule of thumb.

 

[Hello_Darkness]

I believe both the engine oil are 14mm. And the subtrans is 17mm.

So don’t switch sizes could be a rule of thumb.

The engine plugs are 12mm heads

Sub Trans is 17mm

For a Pioneer anyways, Talon is different

 

[CID]

Oh ya! Awesome!

Don't miss that there are two red 'circles' in that photo, both need to be drained. The one in the smaller circle isn't pointing straight down, it's tilted to the right.

 

[PJon]

I’ve been pulling the center of my skid plate off for oil changes. That way I avoid having a lake of oil on top of the skid plate.